ADAPTERS

With an outer TS joint at the top and a smaller inner TS joint at the bottom.Image(s) are representative of the product group and not necessarily the individual product.TS Joint Size Top Outer: 24/40TS Joint Size Bottom Inner: 19/38Approx. Length (mm):...

The arms are approximately 75 DEG apart and are equipped with inner TS 24/40 joints at both ends. Often used as a stillhead adapter.Image(s) are representative of the product group and not necessarily the individual product.

The arms are approximately 105 DEG apart. One end is equipped with an outer TS 24/40 joint and the other end with an inner TS 24/40 joint of the same size. Used as a receiver adapter.Image(s) are representative of the product group and not necessarily...

With full-length inner TS 24/40 joints of same size. The connecting arm is approximately at a 75 DEG angle from vertical and is 200 mm long.Image(s) are representative of the product group and not necessarily the individual product.

Two way tube with arms at 105° angle. Both arms have TS 24/40 joints. Approximate stem length below joint, 170 mm. Vacuum tube O.D., 10 mm.Image(s) are representative of the product group and not necessarily the individual product.

With tubulation of 10 mm OD for attaching to a vacuum pump or to inner and outer TS joints. Includes a drip-tip on the inner tub.Image(s) are representative of the product group and not necessarily the individual product.Standard Taper Bottom Inner...

The sidearm is at an angle approximately 75 DEG from the lower part of the vertical tube. The joint on the sidearm is at an angle approximately 105 DEG from the sidearm. The sidearm and lower tube are equipped with inner TS joints of the same size. The...

This PYREX 105° angle vacuum connecting adapters have an outer 24/40 Standard Taper joint at the top and an inner-sealed through drip-tip joint at the bottom. Bent at a 105° angle. The serrated sidearm has a 10 mm OD. Drip-tip at the bottom...

Made with inner angle of 105°. Upper end is equipped with outer TS 24/40 joint. Lower end cut off at angle for use as a receiver adapter. Tube OD 12 mm.Image(s) are representative of the product group and not necessarily the individual product.

These adapters are fabricated with heavy walls for mechanical strength and are further strengthened by the heavy, uniform rim at the top which affords a serviceable finger grip.These adapters are shorter than the conventional type, thus allowing more...